D.W.C.
Packaging
formerly Don Wilson Company
Over Stock Specials - Click here.
We now offer a shopping cart. Click here.
Celebrating 54 years of service from 1956-2010
|
D.W.C.
Packaging Over Stock Specials - Click here. We now offer a shopping cart. Click here. Celebrating 54 years of service from 1956-2010
|
|
Marsh efi Stencil Ink System Keep the environment cleaner… less than 4% VOC Go green with the efi stenciling system! And now... IN COLOR!!!
The efi stenciling system provides crisp, clear marks on a wide variety of porous and non-porous surfaces. The stencil marks are fast drying, permanent, as well as fade and sunlight resistant. Best of all, since the inks have an ultra-low VOC content, they are more environmentally safe to the operator applying the markings and to the atmosphere. The inks are water soluble and only require soap and water for clean-up. (No separate solvents required!)Since our new efi inks are also non-flammable; they are safer to use and easier to ship than most other stencil inks.
efi Stencil Applicator System The new Marsh efi stenciling system offers you a portable and convenient method of stenciling on both porous and non-porous surfaces. The recommended use of the efi ink is with the applicator that has been specifically designed for efi ink. However, efi ink can also be applied with the RM20 roller and RM50 pad system.
Call for more info on the Electronic Stencil Cutter or the Marsh Super Size Stencil Cutter machines.
MSDS for efi Ink in pdf format: Click here.
Step 1Completely moisten the foam roll attached to the efi roller assembly and squeeze out the excess water. Shake the 4 oz bottle vigorously. Hold the 4 oz bottle in the upright position and remove the cap. Hold the efi applicator head assembly and install by turning the bottle counter-clockwise until bottle is firmly in place. Rotate lever 90 degrees from “off” position. Step 2Hold the roller at a 45 degree angle on a piece of stencil-board and roll it back and forth while gently squeezing the bottle several times until the ink saturates the roll. Make sure the roller is inked uniformly. Rotate the lever to the “off” position. Step 3Place the cut stencil on the surface to be marked. Gently roll the efi inked roller back and forth until the cutout characters are uniformly inked. Do not apply extra pressure when stenciling. Replace roller cover when applicator is not in use. VOC: Volatile Organic Compounds (USA, EU) |
|
